grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

[Dan] salvaged some parts from an old printer a while back and finally found some time to play with them. One of the things he was most interested in is the geared stepper motor seen above. He was ...

The new motor driver supports both sensor-based and sensorless control while aiding configuration with programmable flash.

Today in devices that use stepper motors to make beautiful music we present to you this Arduino-powered, Raspberry-Pi containing music box that uses simple stepper motors to grind out merry tunes and ...

Recently, I found an interesting fan motor module in a web shop and grabbed a couple of them for nothing. At the heart of the module is an eight-pin L9110 DC motor control chip from ASIC (www.asic.net ...

For his entry into the 2019 Hackaday Prize, [Tobius Daichi] is working on adding some motion control capabilities to everyone’s favorite Linux SBC. His 3+Pi board attaches to the Raspberry Pi’s GPIO ...

Toshiba Electronics Europe has introduced the TB67S559FTG 50V/3.0A stepper motor driver IC that supports constant current control with built-in current detection. 50V/3.0A constant current stepper ...